--- a/Output/pjrcUSB/arm/usb_dev.c	Fri Oct 09 22:28:31 2015 -0700
+++ b/Output/pjrcUSB/arm/usb_dev.c	Sun Oct 11 22:07:11 2015 -0700
@@ -911,40 +911,9 @@
 
 void usb_device_reload()
 {
-	if ( flashModeEnabled_define == 0 )
-	{
-		print( NL );
-		warn_print("flashModeEnabled not set, cancelling firmware reload...");
-		info_msg("Set flashModeEnabled to 1 in your kll configuration.");
-		return;
-	}
-
 // MCHCK
-#if defined(_mk20dx128vlf5_)
-
-	// MCHCK Kiibohd Variant
-	// Check to see if PTA3 (has a pull-up) is connected to GND (usually via jumper)
-	// Only allow reload if the jumper is present (security)
-	GPIOA_PDDR &= ~(1<<3); // Input
-	PORTA_PCR3 = PORT_PCR_PFE | PORT_PCR_MUX(1); // Internal pull-up
-
-	// Check for jumper
-	if ( GPIOA_PDIR & (1<<3) && flashModeEnabled_define != 0 )
-	{
-		print( NL );
-		warn_print("Security jumper not present, cancelling firmware reload...");
-		info_msg("Replace jumper on middle 2 pins, or manually press the firmware reload button.");
-	}
-	else
-	{
-		// Copies variable into the VBAT register, must be identical to the variable in the bootloader to jump to the bootloader flash mode
-		for ( int pos = 0; pos < sizeof(sys_reset_to_loader_magic); pos++ )
-			(&VBAT)[ pos ] = sys_reset_to_loader_magic[ pos ];
-		SOFTWARE_RESET();
-	}
-
 // Kiibohd mk20dx256vlh7
-#elif defined(_mk20dx256vlh7_)
+#if defined(_mk20dx128vlf5_) || defined(_mk20dx256vlh7_)
 	// Copies variable into the VBAT register, must be identical to the variable in the bootloader to jump to the bootloader flash mode
 	for ( int pos = 0; pos < sizeof(sys_reset_to_loader_magic); pos++ )
 		(&VBAT)[ pos ] = sys_reset_to_loader_magic[ pos ];